High Power "C" Series - High Power Density High Voltage Power Supplies Fast Rise/Low Overshoot Capacitor Charging & DC Bias Power 0 to 125V through 0 to 6kV @ 0 to 60 Watts, 125 Watts & 250 Watts.
7 models from 0 to 125 Volts through 0 to 6kV
60, 125, or 250 watts of output power
Maximum Iout capability down to 0 Volts
Maximum Iout during charge/rise time
Output short-circuit protection
Very fast rise with very low overshoot
High power density
Output current & voltage monitors
>200,000 hour MTBF @65°C
Fixed-frequency, low-stored-energy design
UL, cUL, IEC-60950-1, and Demko Recognised
This High Power line of high-voltage regulated DC to DC converters is an extension of the “C” Series, directly addressing the high power density needs of >30 watt applications. High Power “C” units provide up to 60/125/250 watts. This high power density is especially suited to high-energy systems with large capacitances, fast repetition rates, or high continuous-DC-power requirements. Output is adjustable from 0 to 125V, 250V, 500V, 1kV, 2kV, 4kV or 6kV on all 60W/125W/250W units. Additionally, 60W/125W models are adjustable from 0 to 8kV, 10kV, 12kV or 15kV. Most fast-rise applications involve charging a storage capacitor, which also acts as an additional output filter/storage capacitor. If your application is continuous DC bias power, an external filter/storage capacitor should be added.
A 100 MegΩ divider provides a 100:1 voltage monitor on models up to 6kV. On models 8kV and higher a 1 GigΩ divider provides a 1000:1 test point. The monitor has an output impedance of 1.1 MegΩ and is calibrated for use with a 10 MegΩ input impedance meter. The High Power “C” Series is equipped with an output current monitor. Current from the high-voltage multiplier can be monitored by reading the voltage generated between Output Monitor pin 3 and Signal Ground pin 5.
The High Power “C” Series provides full power at case temperature from -40 to +65°C. Extended temperature range is available along with other enhanced capabilities.
