The Barth Model Pulse Generator provides high voltage pulses of less than 50ps risetime that can drive into any load impedance without damage to the output switch. It is useful for calibrating sensors because of its clean pulse and very fast risetime.
Specifications:
Output Pulse:
50ps, 10-90%, risetime at all output voltages
Output Amplitude:
Continuously adjustable
Output Pulse Width:
750ps minimum to 5ns, pulse width determined by external charge line. Unit supplied with 5ns charge line, shorter charge lines available as options.
Output Pulse Rep Rate:
Single shot with push-button/external triggering or adjustable from .1Hz to 10Hz
Trigger Input:
5V at 20mA input pulse at up to 10Hz rep rate
Mechanical Switch Life:
>5,000,000 pulses at 2.5kV and 5ns pulse width output (switch life is output pulse energy dependent)
Connectors:
GR 874 locking, with a 'N' female adapter supplied on the output connector
Input Power:
90-132 VAC @ 2.5 amps or 175-264 VAC @1.6 amps (47-63Hz single phase)
Dimensions:
6.0" wide x 10.5" high x 12.5" deep
Weight:
30lbs
Model: 732
The model 732 pulse generator provides pulses of <50ps risetime, 100 volts through 2kV amplitude, to drive into any load impedance through 50ohm coax.
Specifications:
Output Pulse:
<50ps risetime at all output voltages, with <5% overshoot
Output Amplitude:
Continuously adjustable from <100 volts output to >20kV output with <1% output amplitude jitter at maximum output voltage
Output Pulse Rep Rate:
Adjustable in steps from >20 sec/puulse to 120Hz
Trigger Input:
5V at 1mA through a grounding switch, or a 1V, 1us input trigger pulse
Mechanical Switch Life:
>3,000,000 pulses at 2kV/400ns pulse width output (switch life is energy dependent)
Connectors:
GR 874 locking (2.5kV max output) or type N female (2.0kV max output at sea level) charge line and output connectors
Input Power:
Standard 120 volt/60Hz line power at 10 amps (50Hz model available for export)
