102A Series - 1kJ/s (1000W)

ALE Capacitor Charging Power Supply - 102 Series. 1-40kV, 1000J/sec

FEATURES:

Reduced Package size
On-board PFC
Remote Controls
High EMI-RFI Immunity
TUV safety approved (on most models)

The ALE model 102A is an OEM style High Voltage Power Supply designed for operation in two modes. In the most common format it is a constant current Capacitor Charging Supply which will reliably charge HV capacitors and Pulse Forming Networks (PFN's). The 102A can also operate as a constant voltage, continuous output DC Power Supply with the addition of an external filter capacitor. The entire OEM series employ ALE's patented parallel resonant inverter topology which results in superior pulse to pulse repeatability compared with conventional series resonant designs.

Specification:

AC Input

Input Voltage (VAC)	Current (PFC)	Current (No PFC)
180-250 47-63Hz	6.6A	10A
90-140V 47-63Hz	N/A	20A

Average Charging Rate
1000 J/s at rated Output Voltage.

Peak Charging Rate
1100 J/s at rated Output Voltage.

Standard Voltage Ranges
1, 1.5, 2, 3, 4, 5, 6,
10, 15, 20, 30, 40 kV.
All models continuously variable from 0 to 100% of rated voltage output.
Linear to within 1% of full scale. Accuracy 1% of rated.

Polarity
Available as fixed Positive or Negative. Please specify.

High Voltage Assembly

Voltage	Medium	Output Cable
1-6kV	Air	Coax RG 58
7-40kV	Oil	12AWG, HV Silicon Type DJ

Input Connector
VDE, UL, CSA, approved.

Power Factor

	Non PFC	PFC
All Models	0.65	0.98

Efficiency
Better than 85%

Stored Energy
Less than 0.3 Joules all models.

Stability
0.2% per hour after 1 hour warm-up.

Pulse to Pulse Repeatability
+/-0.2% to 300 Hz. For higher repetition rates, consult factory

Temperature Coefficient
100 PPM per oC

Ambient Temperature
Storage: -40 to +85 oC
Operating:-20 to +45 oC

Humidity
90% Non-condensing

Protection
The power supply is protected against open circuits, short circuits, overloads and arcs.

Agency Approvals
Certified to meet UL 2601.1, EN60601.1 (TUV) Safety requirements.

Note For PFC Units
When high voltage is enabled using either the "HV Enable" Line or de-activation of the "Inhibit" Line, the power supply will reach normal operation mode (and therefore all other published specifications) within 50 milli-seconds.

Mechanical
5.56"(141mm) x 5.75"(146mm) x 14.2"(361mm)
Weight: 20lbs (9kg)
See Datasheet.

Accessories
- Detachable 8 feet HV cable
- 15 pin "D" plug mating control connector
- Operating manual

Remote Control
Via 15pin d-type connector on rear panel. See Datasheet.

Options

Suffix-LH	"Low Inhibit" - A + 10 to 15 volt (high) signal will allow power supply operation. A 0 to +1.5 (low) signal will inhibit the supply.
Suffix-EN	"Low Enable" - A + 10 to 15 volt (high) signal will disable power supply operation. A 0 to +1.5 volt (low) signal will enable the supply.
Suffix-5V	0 to +5 volt program (0 to full-scale output)
Suffix-LP	Latching overload protection